CKLQZ - 1544-HT ROSIN SOLDERING FLUX

  • MSDS: CKLQZ
  • Manufacturer: KESTER SOLDER
  • Product Name: 1544-HT ROSIN SOLDERING FLUX
  • National Stock Number: 3439-00-400-1972
Product Identification

Product ID:1544-HT ROSIN SOLDERING FLUX
MSDS Date:08/10/1998
FSC:3439
NIIN:00-400-1972
Status Code:A
MSDS Number: CKLQZ

Responsible Party
KESTER SOLDER
515 E TOUHY
DES PLAINES, IL 60018
US

Emergency Phone: 847-297-1600

Info Phone: 708-297-1600

Cage: 75297

Contractor
KESTER SOLDER DIVISION OF LITTON SYSTEMS, INC.
DES PLAINES, IL 60018 US

Telephone: 847-297-1600

Cage: 75297

Ingredients

MODIFIED ROSIN

CAS: 65997-05-9


HIGH BOILING GLYCOL BAS

Hazards

Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:TARGET ORGANS: EYES, SKIN, MUCOUS
MEMBRANES & RESPIRATORY SYSTEM. ACUTE: INHALATION: FUMES DURING
SLODERING MAY IRRITATE MUSOUS MEMBRANES & RESPIRATORY SYSTEM. SKIN:
LOCAL IRRITATION. SKIN ABSORPTION: NONE. EYE: IRRITATION FROM
CONTACT WITH LIQUID & SMOKE FROM SOLDERING.INGESTION: BURINGI
SENSATION IN THE DIGESTIVE TRACT. CHRONIC: SMOKE DURING SOLDERING
WILL CONTAIN ROSIN WHICH IS AN ALLERGEN & C AN CAUSE RESPIRATORY
SYSTEM IRRITATION & DAMAGE.
Explanation of Carcinogenicity:NOT LISTED.
Effects of Overexposure:ACUTE: INHALATION: HIGH CONCENTRATIONS CAN
CUASE HEADACHE, DIZZINESS, NARCOSIS & NAUSEA. CHRONIC: BREATHING
VAPORS CAN RESULT IN HEADACHE, DIZZINESS, NARCOSIS & IRRITATION OF
THE MUCOUS MEMBRANES.
Medical Cond Aggravated by Exposure:CHEMICAL HYPERSENSITIVY, ASTHMA &
OTHER RESPIRATORY CONDITIONS. CONTINUED BREATHING OF HIGH
CONCENTRATIONS OF ALCOHOL VAPORS CAN AFFECT THE LIVER & CENTRAL
NERVOUS SYSTEM.

First Aid

First Aid:SEEK MEDICAL ASSISTANCE FOR FURTHER TREATMENT, OBSERVATION &
SUPPORT IF NEEDED. EYE: FLUSH EYES WITH PLENTY OF WATER & GET
MEDICAL ATTENTION. REMOVE ROSIN FROM AROUND EYES WITH A DILUTE
ETHANOL SOLUTI ON. SKIN: WASH THOROUGHLY WITH SOAP & WATER.
INHALATION: REMOVE VICTIM TO FRESH AIR. INGESTION: INDUCE VOMITING
& GET PROMPT MEDICAL ATTENTION.

Fire Fighting

Flash Point Method:TOC
Flash Point:=84.C, 183.2F
Autoignition Temp:Autoignition Temp Text:N/E
Lower Limits:1.5
Upper Limits:9.7
Extinguishing Media:CARBON DIOXIDE, ALCOHOL FOAM, DRY CHEMICAL.
Fire Fighting Procedures:USE WATER SPRAY TO COOL FIRE EXPOSED
CONTAINERS & CONTROL VAPORS.
Unusual Fire/Explosion Hazard:A MODERATE EXPLOSION HAZARD EXISTS WHEN
EXPOSED TO HEAT OR FLAMES.

Accidental Release

Spill Release Procedures:REMOVE ALL IGNITION SOURCES. PROVIDE ADEQUATE
VENTILATION. ABSORBANTS, SUCH AS VERMICULITE, CAN BE USED TO SOAK
UP THE SPILLED LIQUID OR FLUSH AWAY WITH PLENTY OF WATER. CLEAN UP
RESIDUAL WITH ALKALIN E DETERGENT.

Handling

Handling and Storage Precautions:STORE AWAY FROM SOURCES OF IGNITION.
STORAGE AT TEMP BELOW 40 DEG F ( 4 DEG C) MAY RESULT IN
PRECIPITATION OF SOME ROSIN. OPEN CONTAINERS CAUTIOUSLY TO ALLOW
VENTING OF ANY INTERNAL PRESSURE.
Other Precautions:EMPTY CONTAINERS MAY CONTAIN PRODUCT RESIDUE. OBSERVE
ALL LABEL PRECAUTIONS.

Exposure Controls

Respiratory Protection:WHEN VENTILATION IS NOT SUFFICIENT TO REMOVE
FUMES FROM THE BREATHING ZONE, A NIOSH APPROVED RESPIRATOR SHOULD
BE WORN.
Ventilation:LOCAL EXHAUST VENTILATION IS PREFERRED TO MINIMIZE
DISPERSION OF SMOKE & FUMES INTO THE WORK AREA.
Protective Gloves:PLASTIC OR RUBBER GLOVES WHERE NECESSARY TO AVOID
SKIN CONTACT.
Eye Protection:SAFETY GLASSES OR GOGGLES WHEN SPLASHING IS LIKELY TO
OCCUR.
Other Protective Equipment:IMPERMEABLE APRON WHEN SPLSHING IS LIKELY TO
OCCUR.
Work Hygienic Practices:WASH HANDS THOROUGHLY BEFORE EATING OR SMOKING.
Supplemental Safety and Health

Chemical Properties

HCC:V4
Boiling Pt:=176.7C, 350.F
B.P. Text:(760 MM HG)
Vapor Pres:2.3@107 F (MM HG @ 20 C)
Vapor Density:3.5(AIR=1)
VOC Pounds/Gallon:524
Evaporation Rate & Reference:0.07 (BUTYL ACETATE=1)
Solubility in Water:50 (% BY WEIGHT)
Appearance and Odor:THICK, DARK AMBER LIQUID WITH MILD ODOR
Percent Volatiles by Volume:50%

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING MATERIALS.
Stability Condition to Avoid:NOT ESTABLISHED.
Hazardous Decomposition Products:WHEN HEATED TO SOLDERING TEMPERATURES,
THE SOLVENTS ARE EVAPORATED & ROSIN MAY BE THERMALLY DEGRADED TO
LIBERATE ALIPHATIC ALDEHYDES, ACIDS & TERPENES.
Conditions to Avoid Polymerization:WILL NOT OCCUR

Disposal

Waste Disposal Methods:ACCORDING TO LOCAL REGULATIONS, USUALLY BY
INCINERATION. EPA HAZARDOUS WASTE NUMBER IS D001. HAZARD CLASS IS
IGNITABLE WASTE.

Toxicology

Toxicological Information:EXPOSURE LIMITS: NOT DETERMINED FOR THE
PRODUCT. PRIMARY EXPOSURE DURING SOLDERING IS TO EVAPORATED GLYCOL
SOLVENT WHICH MAY CONTAIN DROPLETS OF ROSIN AND/OR ORGANIC
DECOMPOSITION PRODUCTS.

Other Information

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.

Transport

Transport Information:DOT: COMBUSTIBLE LIQUID N.O.S. TDG: NOT
REGULATED.